for an ad-free Fetcheveryone experience!

Garmin

1 lurker | 222 watchers

The_Saint Jul 2008 2:41pm, 25 Jul 2008 507 posts	Quote Pin The_Saint When I had that problem it was because I didn't realise that I'd never fully charged the battery, magically once I did it became loud
Red Tomato Jul 2008 3:11pm, 25 Jul 2008 4,834 posts	Quote Pin Red Tomato my splits work on the bike pix, not sure how i did it,Ii will look when I get home.
flanker Jul 2008 4:10pm, 25 Jul 2008 8,638 posts	Quote Pin flanker There is a way to change the frequency of the tone the beeps use. To do so you have to put it in diagnostic mode, which I think is turning it on with enter held down. Google it and you will find it. It may also help to clean any gunk out of the holes on the back, but be careful if you do this that you don't pierce the thin waterproof membrane that sits underneath the holes, otherwise the insides of the garmin tend to get very wet when it rains and that isn't very good for them speaks from experience
EvilPixie Jul 2008 4:13pm, 25 Jul 2008 5,443 posts	Quote Pin EvilPixie thanks RT I seem to have the ability not to hear my bleeps! Those running with me hear them though
flanker Jul 2008 4:21pm, 25 Jul 2008 8,639 posts	Quote Pin flanker was bored at work, so... to change volume: turn on in test mode by holding down enter at the same time ... press mode to get to the beep frequency page ... turn sound on/off with enter button ... change frequency with the scroll button ... power off and it should retain the last frequency used. simple eh But like Pix I still don't hear my beeps LOL
EvilPixie Jul 2008 4:27pm, 25 Jul 2008 5,444 posts	Quote Pin EvilPixie and what about my question flanker seeing as you are bored! wanders off to play with garmin volumn to annoy office
flanker Jul 2008 1:14am, 26 Jul 2008 8,640 posts	Quote Pin flanker I needed to get home and to a garmin to answer yours and.... it works exactly the same in bike mode as in run mode but you need to turn it on for each mode individually (via training - training options - auto lap)
Pammie Jul 2008 5:34pm, 26 Jul 2008 2,924 posts	Quote Pin Pammie I have a question for Garmin users I want to change the HR zones on my Garmin? How would i do that? Thank you
Bob! Jul 2008 6:59pm, 26 Jul 2008 1,169 posts	Quote Pin Bob! Pammie is it a 305? if so: settings/ other/ HR zones
Bob! Jul 2008 7:01pm, 26 Jul 2008 1,170 posts	Quote Pin Bob! and I have another question when you go in to the setup by holding enter when you turn it on the fiirst page shows amongst other things the current temperature. Where does it get that from?